EyeTrackVR mounts for the WidmoVR prescription lens on the valve index

⚠️Print at your own risk, don't expect this to work perfectly. I jerry rigged this in blender with little to no CAD/3D modeling experience, Improvements may be made in the future

As of right now, the nose LED does poke my nose slightly. However a little electrical tape could be a bandaid fix

This is modeled after -

Lerx-cnm's Widmo insert model

Physics-Dudes v18 eyetracking mount

V2 Mount

Install the mount while your WidmoVR lens is not on the index. Take it off before installing

1. You will have to line up the mount from the camera mount side so it is slightly under the Widmo's little lip at the lens. At this point the nose LED should be slightly peeking over and not fully down.

⚠️ Avoid pushing down on the LED clips and camera clips as they can break easily

2. Push that area down firmly (While still holding the rest of the mount in place) until you push it ever so slightly so it snaps into place.

3. Push down on the rest of the mount to make sure everything is down securely.

4. After the mount is one with the WidmoVR lens, you can place it back onto the index lens as normal.

2024-01-13.09-20-18-00.02.24.936-00.02.55.683_FFB.mp4

WidmoFitTest file

Snap/friction fit over the WidmoVR lens, but with nothing on it. Use as a template/base to add your own led/camera mounts It is a bit of a tight fit, or may change depending on printer tolerance, ymmv, scale up 1% if its too tight

Attribution

From: Lerx-cnm's Widmo insert model Repo

• The WidmoVR ETVR mount is an edited version of a REVERSE ENGINEERED version of WidmoVR's Valve Index Prescription Mount. All credits go to WidmoVR
• This repository does not grant any rights or licenses for the original WidmoVR 3D model.
• Users should respect the original creator's rights and licensing terms, if applicable.
• Any use, modification, or distribution of the original WidmoVR model should be done in accordance with its respective license, if one exists.